Error 8150202C “Specified field network device does not exist” for (RC8/RC8A)

  1. Home
  2. Knowledge Base
  3. RC8/RC8A
  4. Error 8150202C “Specified field network device does not exist” for (RC8/RC8A)

**Attention**: Read this resource material carefully and in its entirety before use, to ensure it is understood and used properly.  Failure to properly follow the instructions in the resource materials DPAM provides may result in damage to your equipment.  As a result, by using the resource materials, you are assuming the risks associated with modifying your equipment. DENSO holds no liability, implied or otherwise, for damage, injury or any legal responsibility incurred, directly or indirectly from the use of the resource materials, including any loss of data or damage to property which may occur by your use of the resource materials. The use of the resource materials are not recommended unless you have technical knowledge and functional experience with the equipment and related software. DENSO is unable to provide support, remote or otherwise, for the information included in the resource material, nor for the ancillary topics relating to the information included in the resource materials. Therefore, if you are not fully comfortable with it, we strongly recommend that you send your unit to one of our Regional Support Centers for repair.  The information contained in the resource materials are subject to change at the sole discretion of DPAM.


Problem

If you see the following error this means that within your project the designated field bus is not set correctly.

Related Error codes:
8150202C

Solution

To correct this error you will need to first open a fresh version of your Wincaps III project.

To correct this error you will need to first open a fresh version of your Wincaps III project.

Then you will go to Project -> Properties

Then select the I/O tab at the top and click on the drop down arrow next to “Device”

Select the field bus card you have installed in your controller. If you do not have an additional card installed (DeviceNet, Ethernet IP, CC-Link, etc.) then you will need to select “Mini IO” and then click “OK”.

Then go to Connect -> Transfer Data -> Extend “Parameter” and check the I/O box -> Click “Send”

Once you have completed downloading your changes you will need to reboot your controller.

The error should be gone once the controller reboots

Owner’s Manual Reference

https://www.fa-manuals.denso-wave.com/en/usermanuals/001061/


Was this article helpful?

Related Articles