Loading Programs to different controllers via USB (RC8/RC8A/COBOTTA)

  1. Home
  2. Knowledge Base
  3. RC8/RC8A
  4. Loading Programs to different controllers via USB (RC8/RC8A/COBOTTA)

**Attention** : Read this resource material carefully and in its entirety before use, to ensure it is understood and used properly.  Failure to properly follow the instructions in the resource materials DPAM provides may result in damage to your equipment.  As a result, by using the resource materials, you are assuming the risks associated with modifying your equipment. DENSO holds no liability, implied or otherwise, for damage, injury or any legal responsibility incurred, directly or indirectly from the use of the resource materials, including any loss of data or damage to property which may occur by your use of the resource materials. The use of the resource materials are not recommended unless you have technical knowledge and functional experience with the equipment and related software. DENSO is unable to provide support, remote or otherwise, for the information included in the resource material, nor for the ancillary topics relating to the information included in the resource materials. Therefore, if you are not fully comfortable with it, we strongly recommend that you send your unit to one of our Regional Support Centers for repair.  The information contained in the resource materials are subject to change at the sole discretion of DPAM.

Overview

It is possible to both save and load robot projects to your DENSO controller via the USB ports found on the front of the controller.

Please see the article relating to this found on online manuals at the DENSO Wave Website:

https://www.fa-manuals.denso-wave.com/en/usermanuals/004412/

https://www.fa-manuals.denso-wave.com/en/usermanuals/002290/


Was this article helpful?

Related Articles